
24
BLOWER DUCT APPEARS TO JUMP WHILE OSCILLATING
1. The blower duct may be fastened too tight against the top of the WayCool®. The nut above
the brace should be loosened allowing 1/16” clearance between the bottom of the blower
duct and the top of the WayCool®.
2. If the blower duct is not too tight, the linkage may be damaged. Look for visible damage to
the linkage rod or the lever. If any of the linkage parts are damaged, they will need to be
replaced.
EXCESSIVE NOISE
1. The blower duct may be fastened too tight against the top of the WayCool®. The nut above
the brace should be loosened allowing 1/16” clearance between the bottom of the blower
duct and the top of the WayCool®.
2. If the blower duct is not too tight, the linkage may be damaged. Look for visible damage to
the linkage rod or the lever. If any of the linkage parts are damaged, they will need to be
replaced.
3. A motor bearing may have failed. If the noise is determined to be coming from the motor,
the bearing may have failed and the motor may need to be replaced.
BLOWER DUCT LIFTS UP OUT OF RECESS IN TOP OF UNIT
1. The blower duct may be too loose. There should be approximately 1/16" clearance
between the blower duct and the top of the WayCool®.
2. The linkage may be damaged. Look for visible damage to the linkage rod or the lever. If
any of the linkage parts are damaged, they will need to be replaced.
*WARNING - If the top of the unit is removed for troubleshooting or any other reason, the wires
from the gear motor must be first disconnected from the oscillator switch. This can be done by first
removing the (2) female disconnects that are attached to the back of the switch.
OPTIONAL ACCESSORIES
PNEUMATIC WHEEL OPTION
Pneumatic wheels are available at the time of your WayCool® purchase
or as a retrofit kit on a previously purchased WayCool®.
The pneumatic wheel options includes two locking and two non-locking
wheels.
Pneumatic wheels are designed to allow for easy rolling on rough or
uneven surfaces.
Comentarios a estos manuales